Drawing walls

The inside face, typed lengths, the room side, thickness and drywall build-ups.

The line is the inside face

When you draw a wall you draw one of its faces: the one that looks into the room. The wall’s thickness is then built off that line, away from the room. The corners you tap are the inside corners.

This is why clear sizes stay true. A room drawn 400 by 300 is 400 by 300 clear, with 24 cm walls or 36.5 cm walls.

If you would rather draw centre lines, set Line is to Centre in the context bar of the Wall tool.

Drawing

  1. Pick Wall (W) and choose Existing or Drywall in the context bar.
  2. Tap the corners one after the other. Every tap adds a wall from the last corner.
  3. Finish with Esc, Return, Finish in the context bar, or by tapping the last corner again. Tapping the first corner closes the room.

A corner tapped on an existing wall splits that wall and joins it as a T.

Typed lengths

While a run of walls is open, type a number and press Return: the next wall gets exactly that length in the direction of the pointer. On a touch screen, type the length in the context bar and then tap in the direction.

Angles

The Angle menu in the context bar sets the directions a wall may take: Square (horizontal and vertical), 15° steps or Free. On a keyboard, Shift gives 15° steps and Option any angle for as long as you hold it. Square is the same as the Ortho switch in the status bar.

Which side is the room

Clearline works out the room side from the shape: for an L, a U or a closed room, the room is on the inside of the bend. If a wall builds into the room instead of away from it, select it and press F, or use Other side. Before drawing, F flips the side for the walls you are about to draw.

Changing a length later

Select a wall, then either tap its dimension label, type a number, or use Length in the context bar. The field sets the clear length: the distance between the faces of the walls at either end.

Choose which end moves: Left, Right or Both (Bottom and Top for vertical walls); Tab in the length field cycles through them. Walls connected to the moving corner go with it, so a rectangular room stays rectangular.

Dragging works too: drag a wall to move it sideways, drag a corner to move the corner. With Ortho on, every wall attached to that corner stays square.

Thickness and height

In the inspector:

  • Thickness and Height of the selected wall. [ and ] make a wall 1 cm thinner or thicker.
  • Thickness grows Outward (the default: your line is the inside face), Both ways (centre line) or Inward (your line is the outside face).

The defaults for new walls are in the inspector when nothing is selected: existing walls 24 cm, height 250 cm.

Drywall build-ups

A drywall wall is described by what it is made of:

Setting Values
Stud profile CW 50, CW 75, CW 100
Board layers, room side 0 to 3, each 12.5 mm
Board layers, other side 0 to 3, each 12.5 mm
Board type per side Standard, moisture (green), acoustic (blue)
Insulation on or off

The thickness follows from the build-up. The default is CW 75 with two layers on each side and insulation: 12.5 cm. The plan draws the boards and the insulation, and the build-up feeds the material list.

Typing a thickness for a drywall wall turns it into a plain wall of that thickness; Use a stud and board build-up brings the build-up back.

Rooms

A closed loop of walls is a room. With nothing selected, the inspector lists every room with its clear width, depth and area.