Heating and floor heating
Supply and return pipes, floor heating zones, radiators and the manifold.
Pick Supply pipe, Return pipe or Floor heating in the Heating section of the library, or press E and choose in the context bar.
Pipes
Supply and return are routed like any other line: tap the points, finish with Return or Finish. Both are drawn dashed, the supply in red and the return in blue.
Floor heating zones
A zone is the area one heating circuit covers.
- Choose Floor heating and the spacing: 10, 15 or 20 cm.
- Tap the corners of the area.
- Tap the first corner again to close it.
The zone is drawn with its pipe loop: a meander, or a counter-flow spiral in which supply and return run side by side. The loop starts where the supply and return pipes from the manifold reach the zone, so route those two pipes to it. The label gives the area and the spacing; the lengths of the loop and of the feeds are shown with it and in the inspector.
Lengths are worked out from the drawing. Take them as a planning value and let the installer confirm the circuit lengths.
Select a zone to move its corners, add corners on the middle of an edge, or change the spacing in the inspector. Shift-click selects several corners, which then move together with the arrow keys.
Radiators and the manifold
Radiator and Floor heating manifold are objects in the Heating section. Place them on a wall like any other object; width, height and the height above the floor are in the inspector.
In the material list
- supply and return pipe, by length
- floor heating per zone and in total, with area and spacing
- radiators and manifolds, by count
The layer
Everything here is on the Heating layer.