Guides and snapping
Helper lines, what the pointer snaps to, and how to switch it off.
Guides
A guide is a helper line across the whole plan, vertical or horizontal. It is not part of the building and is left out of exports.
- From a ruler: drag out of the left ruler for a vertical guide, out of the top ruler for a horizontal one.
- With the tool: pick Guide (G), choose Vertical or Horizontal, and tap. Shift places the other direction.
- Move: drag it with the Select tool, or type its position in the inspector.
- Parallel to a wall: select a guide and set it at an offset from a wall’s inside face in the inspector. Useful for “60 cm off this wall”.
- Remove: drag it back onto a ruler, press Delete, or use Clear all in the Guide tool’s context bar.
The Guides switch in the status bar hides the guides and stops snapping to them.
What snaps
While you draw or drag, the point under the pointer snaps, in this order of preference:
- Corners of walls
- Guides, and where two guides cross
- Walls: a point on a wall, which becomes a T-joint
- The grid
The status bar names what the point snapped to: Corner, On wall, Guide, Grid or Straight.
When the direction is fixed (Ortho, or Shift for 15° steps), the point stays on that line. Corners, walls and guides then decide how far along the line it lands: level with another corner, on a wall it crosses, on a guide.
The grid
The snap grid is set in the inspector when nothing is selected; the default is 1 cm. When you zoom out, the step grows to the next round length so the pointer still lands on a visible point, and round numbers such as 300 stay reachable.
Objects
Dragged objects snap with their edges and centre to wall faces, other objects and guides. Doors, windows and objects are pulled onto guides before they find their wall.
Without snapping
Hold Option while drawing or dragging: any angle, no snapping. Without a keyboard, switch on Snap off in the context bar; it stays on until you switch it off again.