Electrical
Sockets and switches as frames with inserts, cable routes and the count of what to buy.
Outlets and switches
Pick Outlet or Switch in the Electrical section and tap a wall. The device sits on the wall’s inside face.
A device is a frame with one to five inserts, side by side or stacked:
| Group | Inserts |
|---|---|
| Sockets | Socket, USB socket |
| Switches | Switch, two-way switch, series switch, push button, dimmer |
| Other | Network (LAN), TV / SAT, blank cover |
In the inspector, add inserts, reorder or remove them, and choose horizontal or vertical. The frame grows with its inserts (71 mm from centre to centre). The next device of the same kind starts with the combination you used last.
Mounting height
The height is the centre of the frame above the floor. A new outlet is placed at 30 cm, a new switch at 110 cm. The inspector has presets for the usual heights:
| Preset | Height |
|---|---|
| Socket | 30 cm |
| Switch | 105 cm |
| Above a worktop | 115 cm |
Any other height can be typed.
Cables
Pick Cable (C) and tap the points of the route. The points snap to corners, walls and guides; the route runs straight unless you hold Shift or Option. Finish with Return, Esc, Finish, or by tapping the last point again. Backspace or Undo point removes the last point.
A selected cable shows its points:
- drag a point to move it
- drag the middle of a segment to add a point
- select a point and press Delete to remove it
- Shift-click further points to select several, and move them together with the arrow keys
- Extend in the inspector continues the route from either end
The inspector shows the length.
Totals
With nothing selected, the inspector lists the electrical totals: inserts by type and frames by size. The material list adds one flush-mount box per insert and the cable, as drawn and with a 10 % allowance.
On paper
The electrical sheet of the PDF plan set shows the devices and cable routes alone on the walls, with the height of each frame written next to it.
The layer
Devices and cables are on the Electrical layer. Use show only in the layers panel for a sheet with nothing but the walls and the electrical installation.